|
Post by redlance305 on Dec 5, 2014 21:39:56 GMT
Good Day.
Wonder if there are instructions to install RaspiVoice from the command line rather than having to create a new SD card from an image? I have a 32 gb card that has be configured over the last couple of weeks, and just don't want to start over.
Just wondering. Thanks ~David
|
|
|
Post by Admin on Dec 7, 2014 0:51:38 GMT
That is a good question. Yes, it should in fact be reasonably simply to install Raspivoice without flashing the entire image. It relies on WiringPi also being installed and then also just one or two command line instructions to make sure it starts up at bootup and also to ensure it redirect audio out via the analog audio jack.
I will note down all the steps required and update this post in a while.
|
|
|
Post by Admin on Dec 7, 2014 4:22:03 GMT
I documented all the steps required to manually install RaspiVoice from command line here: www.raspivoice.com/tips.htmlPlease note that I did not yet have time to try and make a new install from scratch from these steps yet. So if I accidentally left something out, then please let me know and I will fix it. But I think its fairly complete and probably all that you need to do an install without resorting to the image file that you can download at www.raspivoice.com/sdcard_preparation.html
|
|